sipura and RCV from one provider and dialing with another

[yaman]

is there a possibility using sipura to receive a voip call by using one account than obtain a dialing tone to call out using another account with the same sipura device. for example the caller calls a FWD account which is registered on the sipura than obtain a broadvoice dialing tone to call out using the same sipura.

is yes, how?

thanks

[yaman]

i will like to add which sipura is possible to bridge voip to voip, is the spa-3000 the only one and what about spa-2000.

in the case where i install spa3000 within an IPBX that does not support DISA and i need to bridge calls that is coming from PSTN through digium FXO card installed on the IPBX to my SPA3000 line1 and obtain a dialing tone to dial out using line2.

is this possible?

thanks

[mberlant]

What you ask is not possible as you described. This has been discussed many times here, most recently in this thread. You will need to strap your Line 1 and PSTN Line together, as recommended in these threads, to perform VoIP-to-VoIP routing without a SIP PABX.

[yaman]

since this a bit impossible, now is there a possibility to bridge from voip to voip using sipura 2002 and FX-200. so the calls coming in can pass through the FX-200 for authentification and providing a dialing tone to call out using voip.

i guess i saw something like that in voxilla forum but no able to locate it.

thanks for advising

[mberlant]

yaman,

If you look for combinations of FX-200 and SPA-2000 you will find what you want. The SPA-2002 is functionally equivalent to the 2000, and these configurations were sorted out with the 2000.